These “state- of- the- art” durometers are crafted and designed to achieve the highest level of accuracy. Utilized primarily for plastics and rubbers, this series of durometers maintains an easy to use interface with numerous data manipulation features.

Durometers, like many other hardness testers, measure the depth of indentation in the material created by a given force from a standardized indentation tip. Shore A durometers utilize a 35 degree blunt cone tip, while Shore D durometers use a 30 degree sharp point.

The Phase II Durometers offer access in hard to reach areas due to the design of the test tip shank. This produces a marked advantage over flat body designs that are too big to “reach” difficult spots.

Features:

• Measuring range: 0-100HSA (D)
• Deviation: <1%H
• Resolution: 0 .1H
• Digital read out
• Accurate and repetitive deviation = 20~90HSA HSA<+/-1grade
• Conforms to ASTM D-2240, ISO 7619, DIN 53505 standards
• Locks in peak value
• Statistics: Mean Value Max, Min, No. of measurements and Std Deviation
• RS-232 output
• Uses 4 –AAA batteries
• Low Battery Indicator